What are the installation steps of the scaffolding stamping die?

As we all know, the scaffolding stamping parts are actually made by stamping molds. Therefore, if you want to get a better stamping effect, you must ensure that the mold installation is correct and reasonable. So, do you know how to install the stamping die? Let's take a look at the installation steps of the stamping die of the lower scaffolding stamping. First of all, we should know that the installation must be carried out in a certain order. The first step is to properly adjust the height of the press slider according to the closed height of the scaffold stamping die. Under normal circumstances, we should ensure that when the slider is at the bottom dead center, the distance between the bottom surface and the table surface is not less than the closed height of the stamping die. When the distance is determined, we need to raise the slider to this position, and then place the stamping die of the scaffold stamping part at the specified position on the working table of the press. Then, keep the slider at the bottom dead center, and adjust its height appropriately, and finally make the bottom plane of the slider contact with the upper plane of the die seat. Then the mold handle is inserted into the mold handle hole, and the mold handle is fixed by means of a pressure block and a screw. Next, we need to adjust the slider appropriately according to the requirements to make it reach the set position, and then turn on the press to run 1-2 times in a narrow range, so that the slider can be stopped at the bottom dead point and fixed. Mold seat. Then carry out a test punch. In this process, you should keep adjusting the slider until you reach the desired height. Then we can install the stamping die of the scaffold stamping parts based on this result. The above is about the installation steps of the scaffolding stamping die. I hope that after understanding the content of this part, we can deepen everyone's understanding. At the same time, I hope everyone can install the mold correctly to ensure the quality of the product. Related news: The characteristics of the main materials of stamping parts, the handling of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections