One Stop Solution Manufacturer for all kind of Stamping Products and CNC lathed products.
What is the problem of unilateral burrs in metal stamping parts
Metal stamping parts are widely used in various industries, including automobiles, electronics, medical, aerospace, etc. Stamping factories usually encounter some product quality problems when producing stamping parts. Next, we will mainly discuss the problem of point edge burrs on precision stamping parts. After precise analysis, the main reasons for single-sided burrs in metal stamping parts are as follows. 1) Mold assembly error. If the punch is not perpendicular to the fixed plate or is loose due to wear, or the positioning pin is loose, the correct fixing position of the punch and the punch cannot be guaranteed. 2) Poor guidance accuracy. If the matching gap of the die guide is too large, the middle line of the upper die and the lower die does not overlap, which affects the uniformity of the stamping gap. 3) Installation error. When installing non-guided molds, the position of the upper and lower molds is not allowed to cause uneven clearance. The surface of the template or bottom plate of the template is not clean, or the upper die screws are not tightened correctly, which will cause the working parts to tilt. 4) The mold is deformed during work. For example, the leakage hole of the perforated mattress board is too large, the template under the mold is too thin, and the rigidity of the mold is insufficient. 5) The clearance between the perforated guide rails is too large, the parallelism between the bottom surface of the slide block and the working surface is not good, or the sliding direction of the slide block is not perpendicular to the working surface. 6) When the resistance of the workpiece during punching exceeds 80% of the nominal pressure of the punch, it is easy to deform the 'C'-shaped bed of the open punch, so that the middle lines of the upper and lower molds do not coincide. 7) The flatness of the plate is poor, and the punch with a smaller diameter will tilt during the metal stamping process. 8) Due to mold selection, improper forging and heat treatment processes, the mold will be deformed during heat treatment or wire EDM, which will affect the uniformity of the mold gap. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)