What is the reason for the poor surface quality of scaffold stamping parts?

In fact, there are many factors that cause poor surface quality of scaffolding stamping products, and the problems that it ultimately manifests are also diverse. After analysis, the main factors included are coils, sheets, molds, etc. Due to surface problems, the quality of the scaffolding stampings will eventually be affected. In addition, during the entire stamping process, operational factors and tool loading and unloading will also affect the surface quality of scaffold stamping parts. That is to say, in the entire production process, we need to fully consider every detail and try to avoid problems that may arise in Science Energy. In general, the main reasons why the scaffolding stamping parts have the problem of coiling are as follows: 1. The surface of the steel plate or the inside of it has sundries intruding; 2. The coil material is in a scar-like state; 3. The coil material is bad; 4. The corners of the coil material are incomplete; 5. The corners of the coil are deformed or crumpled due to uneven stress. In addition to the main factors introduced above, there are actually some other factors. For example, there are some scratches on the surface of the scaffold stamping parts, which are mainly caused by impurities in them, or caused by the sliding of the rollers. Or if there are irregular defects on the edge of the water-soluble fertilizer equipment coil material, it may also cause the coil material problem of the scaffold stamping parts. These factors are actually relatively common, so I hope you can pay more attention to them. In short, the above is mainly to introduce the more common factors that may cause problems with the surface quality of scaffold stamping parts. I hope that in the future production work, effective measures can be taken to avoid these problems. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections