What problems should be paid attention to when handling the waste of precision metal stamping parts? 'Hardware'

We know that waste disposal is a very dangerous job. We use automated processing as much as possible. Of course, some waste materials have to be processed manually. So what problems should we pay attention to when processing precision metal stamping parts? There may be many friends. I'm not quite sure, let's follow the author to find out. There are two types of waste packaging for precision metal stamping parts, one is automated processing, and the other is non-automated processing. 1. Measures to automatically process the waste of precision metal stamping parts: 1. We can set a cutter on the metal stamping die to cut off the waste, and press the block from the conveyor belt to the baler. In addition, we should pay attention to the pressing Cut off once at a distance. 2. Use a take-up reel to wind the waste. In fact, the appearance of the take-up reel is similar to the strip steel reel. The scrap after precision metal stamping parts can be used as the material of other parts after being wound on the reel. , Because the reel motor is independently driven, it can also be driven by a press or a feeding mechanism. 3. When general sheet metal is used for processing, the waste of precision metal stamping parts is conveyed by the conveyor belt and cut short by the waste shredder , And then press the machine to form a block. 2. Measures for non-automated processing of waste of precision metal stamping parts: 1. In order to prevent accidents, we should install a protective cover and prevent the waste from flowing out or scattering near the operator during operation. 2. The waste should not have sharp corners or burrs, so as not to hurt people, and the size of the waste should be appropriate when cutting the waste, so as not to under the algae near the operator and hurt the operator. 3. If the waste cannot fall by its own weight, once it is caught at the edge of the blade, it should be forced to fall by using throwing, ejection and other falling aid devices. 4. The chute that removes waste must pass to the end of the backing plate and be aligned with the opening of the waste pit. When installing the chute, pay attention to whether the screws of the metal stamping die are tightened. 5. When the waste passes through the pipeline, it should be noted that if the width and height in the straight line are not enough, it is easy to block, and it is also necessary to avoid passing more than two kinds of waste on one kind of pipeline. 6. When obliquely discharging the waste material from punching small holes, the waste material should be automatically broken into layers. At least 100 pieces of waste material should be stored at the upper mold or lower mold seat. If the waste materials in two places are collected together , There must be enough space for stacking. The above is a brief introduction to the problems that should be paid attention to when handling the waste of precision metal stamping parts. The author also reminds friends who are engaged in waste packaging to pay attention to safety and avoid accidents.