What's wrong with the poor size of metal stamping parts?

Metal stamping parts are very common in our lives, but due to the influence of many factors in the processing process, some problems occasionally occur, such as poor size of the metal stamping parts. So, why is there such a behavior? Below we will give you a brief analysis, hoping to help you. In general, the main reasons for this problem can be summarized into four aspects. The first point is that the mold design used is defective, or the size of the metal stamping parts is poor due to poor processing and assembly. However, this reason generally appears in the first production. Therefore, after discovering the problem, we need to make adjustments in time to avoid recurrence. The second reason is that when the mold is placed, the height of the mold is unreasonably adjusted, or the installation is not in place, causing the size of the metal stamping parts to not meet the requirements. In addition, it is also possible that the die head was not locked in time after the adjuster die, which caused the die height to escape during the stamping process. The third reason is that when positioning, the workpiece is not accurately placed in the specified position, or the mold gap becomes larger due to the long processing time, which may cause the size of the metal stamping parts to be poor. The last reason is that due to the loosening of the mold during the processing, the deviation occurs during positioning, which eventually leads to poor dimensions. The above content is mainly to help you analyze the four main reasons for the poor size of metal stamping parts in the processing process. I hope everyone can gain something from it, so as to avoid encountering such problems again in actual work. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections