What should be paid attention to when the metal stamping shrapnel mold is off the machine?

In the stamping process of metal stamping shrapnel molds, due to the use of high-speed punches, the risk factors are high. If the operation is improper, the mold will cause serious damage and the operator’s safety will be injured. Therefore, the mold needs to be put down. Ensure safety. Molds and operators. What should we pay attention to? The metal stamping shrapnel mold should pay attention to the matters that the next machine tool should pay attention to: 1. When the mold is normally closed, it is necessary to guide the mold into the round hole. 2. Pay attention to the following parts of metal stamping shrapnel molds. After the mold, the host and other power supplies will be turned off to avoid wasting resources. 3. Before pulling the mold, confirm that the material strip of the mold feed inlet has been loosened and disassembled. 4. The abnormal lower mold should not be operated again, especially after the mold stops. 5. When the die is pulled away from the die, the die cart cannot rotate too fast. Prevent the guide plate or material bracket from hanging the punch or punch guard, causing damage to the mold parts or mold slips. 6. When the mold is not moving, it can be pulled outwards and one pushed back. (Avoid two people pushing back at the same time and pushing the mold out of the punching table), or use the lifting screw to rotate the threaded hole of the lower mold base. The above 6 points are the next thing to pay attention to about metal stamping shrapnel molds. Everyone should pay attention when using metal stamping molds to prevent unnecessary accidents.