What should the stamping parts manufacturer do if the punch of the stamping die is easy to break?

Due to various reasons such as mold design, mold steel, stamping materials, etc., unreasonable phenomena will cause the punch of the stamping die to break. So how should stamping parts manufacturers control this situation? Xiaoshuo shares with you: (1) The closing height is too low, and the cutting edge of the punch is too long to adjust the closing height (2) The material positioning is improper, causing the punching punch to cut one side, adjusting the positioning or the feeding device due to uneven force Fracture (3) The scrap of the lower mold blocks the knife edge, causing the punch to break and re-drill the large blanking hole to make the blanking smooth. (4) The fixed part (splint) and the guide part of the punch are repaired or re-cut into the block to make the punch Smooth up and down (strike) deviation (5) The guide of the punch is poor, causing the punch to be forced on one side to refit the punch gap (6) The punch blade is too short, and the punch is interfered with the punch, and the length of the blade is increased. (7) The punch is not fixed well, move up and down to fix the punch again so that it cannot move up and down. (8) The cutting edge of the punch is not sharp. Re-grind the cutting edge. (9) The surface of the punch is strained and the force is not applied during stripping. Replace the punch (10) The punch is too thin, too long, and the strength is not enough. Change the punch type (11) The hardness of the punch is too high, the material of the punch is wrong. Change the material of the punch, adjust the heat treatment hardness for 15 years, and the hardware is in the production process In, encountered many on-site situations. As a stamping parts manufacturer that serves many companies, people face difficulties, overcome one difficulty after another, and have achieved one result after another. Choose, choose to rest assured!