What to pay attention to when filling oil in stamping parts processing

Precision is an enterprise specializing in customized processing of precision stamping parts, with more than ten years of experience. In the process of stamping parts processing, there is a very important step, that is, oil injection. Next, I will introduce precisely what should be paid attention to in the process of stamping parts processing. There are certain requirements for the amount and frequency of oil injection in the processing of stamping parts. The amount and frequency of oil injection depend on the raw materials of the precision stamping parts produced and processed; in the processing of stamping parts, cold-rolled steel plates, corrosion-resistant thick steel plates, etc. For rust-free raw materials, the mold should be filled with oil. The oil injection points are the guide post, the oil drip port, the surface of the cutter body and the guide post, and the upper mold. Use light automobile engine oil; For the rusty and dirty raw materials in the processing of stamping parts, the rust powder will be sucked into the center of the punching needle and the guide post during the production process, causing stains, and prompting the punching needle to not be dragged in the guide post at will. Under such conditions, if oil is applied, it will make the rust and dirt more likely to be stained. Therefore, when flushing such raw materials, the oil should be wiped off and dissolved once a month. Remove the stains on the upper mold and wipe it clean before assembling again to ensure that the mold has excellent lubricating properties. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)