Which aspects of the stamping parts processing workshop should pay attention to the load situation?

The stamping parts processing workshop must take into account the load requirements of various equipment and facilities, what kind of state is reached, and what is the load? It refers to the external force exerted on the object. Where do you need to pay attention to the load in the stamping parts processing workshop? Stamping parts processing manufacturers will take you to take a look; 1. The load of the press; it depends on the load of the press, the weight of the die change cart and the weight of the die. Since the mechanical press will produce a large impact load when it is working, the pressure is calculated The load of the crane needs to be considered; 2. The load of the crane; the crane used in the stamping parts processing workshop generally chooses 32t and 50t cranes. It is necessary to look at the product specifications, wheel pressure, wheelbase and other parameters of the crane, and calculate Its maximum load; 3. Pipeline load; there will be water, electricity, gas, wind, fire and other pipelines on the pillars of the stamping parts processing workshop. This aspect should also be considered when calculating the load; 4. Floor load; stamping parts Except for the press line area, most of the area of u200bu200bthe processing workshop is used to store molds. Generally, the number of mold stacking layers is two. Therefore, the floor load of the workshop is about 100KPa. The raw material coil or sheet stacking area of u200bu200bstamping parts needs to be stacked according to the stacking form However, if the special rack is used for stacking and exceeds the second floor, the floor load needs to be considered 150KPa; Article recommendation: Introduction to the characteristics of the automation equipment for the production of metal stamping parts Previous: The use and characteristics of the drawing press for stamping parts processing equipment