Wuxi metal stamping processing plant, the cause of distortion and processing + 3 million punching next day production capacity

Some mold masters of Wuxi metal stamping processing factories often discuss together, saying that when producing some more complicated stamping structural parts, they will encounter some material distortion and deformation problems. Reduced production capacity, reduced efficiency, and caused a variety of undesirable problems. The following Xiaoshuo will work with you to analyze the reasons and solutions: The reasons for the distortion and deformation are mostly due to the gap force and the reaction force that do not generate a moment on the same line (the gap between the punch and the die is too large and the die edge has a reverse taper. Or the contact area between the ejector and the workpiece is too small to cause warping deformation). Aiming at the distortion and deformation mentioned by the Wuxi metal stamping processing manufacturer, Xiaoshuo recommends the following solutions: The blanking gap should be selected reasonably, and the die structure should increase the pressure plate (or pallet) plate and the pressure plate plane contact and There is a certain amount of pressure; if there is a back taper on the cutting edge of the die, the cutting edge of the die must be trimmed properly; if it is due to the complex shape of the punching part and the uneven shear force when there are many inner holes, the blanking force will increase, before punching Just press the strip or use a high-precision press for punching; the plate should be leveled before punching, if the warpage cannot be removed, the workpiece after punching can be leveled again through the leveling die; clean the mold regularly For the stolen goods in the cavity, the surface of the thin sheet is lubricated, and the mold structure is provided with oil and gas holes. Hardware, 15 years of focus on Wuxi metal stamping processing plant, rich experience in custom processing and production of 20,000+ sets of molds, product accuracy can reach 0.01mm, daily production capacity of 3 million strokes and 16 quality inspections strictly for quality control. It can quickly solve your time-critical problems, solve your product accuracy problems, and solve your hardware stamping parts quality requirements. Choose, choose rest assured!