Xiangyang hardware stamping parts, what are the reasons for the waste during stamping + 16 strict quality inspections

The hardware technicians of the manufacturer responsible for the manufacture of hardware stamping parts in Xiangyang said, what is the reason for the stamping waste during the processing and customization of metal stamping parts, the following hardware Xiaoshuo will give you an analysis of the causes and solutions according to the specific practical situation. : 　　1) Reason: 　　 The quality of raw materials is poor; the die is installed, adjusted, and used improperly; the operator does not feed the strip correctly along the positioning or does not guarantee that the strip is fed according to a certain gap; due to long-term use, the gap changes or itself The working parts and guide parts are worn out; the punching die has been subjected to shock and vibration for too long and the fastening parts are loosened, so that the installation positions of the punching die are relatively changed; the operator's negligence and failure to operate according to the operating rules. 2) Countermeasures: 　　The raw materials must conform to the specified technical conditions (strictly check the specifications and grades of the raw materials, and conduct laboratory inspections on the workpieces with high dimensional accuracy and surface quality requirements under conditions.); as specified in the process regulations All aspects of the process should be strictly observed; the presses and die and other tooling equipment used should be guaranteed to work in normal working conditions; a strict inspection system must be established during the production process, and the first stamping parts must be fully integrated Inspection, production can only be put into production after the inspection is qualified, and at the same time, the inspection should be strengthened, and the accident should be dealt with in time;> The cutting-edge numerical control technology WeChat is good, remember to pay attention. Adhere to a civilized production system, such as the transfer of workpieces and blanks, must use appropriate workstations, otherwise the surface of the workpiece will be crushed and scratched, which will affect the surface quality of the workpiece; ensure that the mold cavity is clean and work during the stamping process. Workpieces that need to be organized and processed in an orderly manner should be placed neatly. Hardware, 15 years of focus on Xiangyang hardware stamping parts, 20,000+ sets of customized stamping die production experience, monthly processing capacity of 100+ sets of molds, hundreds of precision processing production equipment, daily production capacity of 3 million punches, and silk-like stamping accuracy up to 0.01 mm, the raw materials are imported and the original national standard factory, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!