Hangzhou hardware stamping parts exporter, composite process + 15 years of experience and stamping with less effort

The composite stamping mentioned by Hangzhou hardware stamping exporters does not refer to the composite stamping process of blanking, drawing, punching, etc., but the composite stamping process with other processing processes, such as the composite stamping and electromagnetic forming. What are its specific contents? The following Xiaoshuo sorted out some relevant information, and take everyone to take a look: Electromagnetic forming is high-speed forming, and high-speed forming not only expands the aluminum alloy forming range, but also improves its forming performance. The specific method of forming aluminum alloy cover parts by composite stamping is: use a set of convex and concave molds to install electromagnetic coils at the sharp corners and difficult-to-form contours of the aluminum alloy cover parts, form them by electromagnetic methods, and then use a pair of molds The easy-to-form part of the cover is formed on the press, and then the preform is deformed at a high speed with an electromagnetic coil to complete the final forming. Facts have proved that using this composite forming method can obtain aluminum alloy panels that are difficult to obtain with a single stamping method. The latest research shows that magnesium alloy is a metal with high specific strength, good rigidity, and strong electromagnetic interface protection performance. Its application prospects in electronics, automobiles and other industries are very promising, and it can replace traditional ferroalloys, aluminum alloys, and even plastic materials. trend. Magnesium alloy parts currently used in automobiles include instrument panels, seat frames, engine covers, etc. Magnesium alloy pipe parts are also widely used in cutting-edge industrial fields such as airplanes, missiles, and spacecraft. However, the close-packed hexagonal lattice structure of magnesium alloy determines that it cannot be stamped and formed at room temperature. Now people have developed a mold that integrates heating and forming to stamp and form magnesium alloy products. The product forming process is as follows: during the descending process of the punch slide, the upper die and the lower die are clamped to heat the material, and then the material is formed in an appropriate motion mode. Hardware 15 years of ingenuity focused on metal stamping parts processing, 20000+ sets of stamping die customized production experience, monthly 100+ sets of mold processing capacity, hundreds of precision processing production equipment, daily production capacity of 3 million punching times, and stamping accuracy up to 0.01mm, The raw materials are imported and national standard original factories, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!