Hebei metal stamping parts processing plant, stamping protection measures + 3 minutes to take you to understand this knowledge ()

The stamping production staff of the Hebei metal stamping parts processing plant said that in the case of producing dozens or hundreds of stamping parts per minute, the processes of feeding, stamping, discharging, and discharging waste can be completed in a short time. Such an operating environment Personal, equipment, and quality accidents often occur under the environment. Therefore, production in stamping has always been a very important issue. Xiaoshuo sorted out some effective protective measures, and let’s take a look at them: The protective measures for stamping processing have the following points: ①Realize mechanization and automatic feeding and discharging. ②Set up mechanical protection device to prevent hand injury. Use mold guards, automatic return devices and hand tools to feed in and out. ③Set up electrical protection and power-off devices. Set up photoelectric or air curtain protection switch, two-hand or multi-hand series start switch, anti-misoperation device, etc. ④Improve the clutch and brake structure. After the danger signal is sent out, the crankshaft, connecting rod, and punch of the press can immediately stop in their original positions. The various parts on the mold should have sufficient strength and rigidity to prevent damage and deformation during use. The fastening parts should have anti-loose measures to avoid accidental injury to the operator. It is not allowed to produce waste or workpiece missiles during the processing, which will affect the attention of the operator or even hurt the operator. In addition, it is necessary to avoid cuts from the burrs of the blanking parts. Operators are not allowed to have too much motion range during the stamping operation, to avoid losing the body's stable posture; excessive and over-accurate motions are not allowed during the operation. Hardware, 15 years of focusing on Hebei metal stamping parts processing plant, hundreds of processing and production equipment, 20,000+ sets of customized stamping die production experience, monthly processing capacity of 100+ sets of molds, daily production capacity of 3 million punches, and stamping accuracy up to 0.01mm , 16 quality inspections are strictly controlled, focusing on quality and meticulous design. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!